Welcome to Concord Group - We Delivery The Quality - You Enjoy The Convenience!

Monday - Saturday : 9:30 AM to 6 PM

  • Bannerghatta Road

    Bangalore 560076, INDIA

  • Call Us On

    +91-9986662823

  • Mail Us

    sales@concordindia.net

SHUTTERS: GENERAL ARRANGEMENTS OF SHUTTER

The shutter consists of a curtain made up of interlocked standard ms lath sections to the required width and height. the whole curtain is balanced and assembled and wraps round the drum. the drum is supported by anti friction bearings fixed to two side brackets which in turn are fixed to the wall. one of the brackets has a motor with chain and sprocket to drive the drum.



Provide service

GUIDE CHANNEL

The guide channels shall be of mild steel deep channel section of 75mmx 3mm thick bent to profile.



FABRICATION CURTAIN

The curtain shall be built up of interlocking with MS Lathe Section of 75mm MM 18 g thick rolled so as to have inter-locking curls at both edges for resisting manual Pressure & normal wind pressure each lath section shall be continuous single piece without any joint.

BRACKET SET CONSISTS OF THE FOLLOWING

MS Plate, Sprocket, Flange Assembly, Roller chain, Bearings etc.

DRUM ASSEMBLY

The suspension shaft of the roller shall be made of sufficient diameter steel pipe so as to resist defection due to the weight of the rolling shutter. The whole curtain is balanced and assembled/wraps over the drum. The drum is supported by anti friction bearings and is fixed to two side brackets that are fixed to the wall. One of the brackets has a Motor with chain and sprocket to drive the drum.

THE MATCHING ACCESSORIES FOR THE OPTIMAL BARRIER SYSTEM

  • SAFTEY
  • CONVENIENCE
  • Electric lock

    For additional locking and protection from break-in.

  • Rubber profile

    Providing enhanced protection against getting trapped.

  • Light barriers

    Detecting obstacles when the beam of light is obstructed and preventing the gate from closing, they can be installed in a variety of scenarios and are even suitable for outdoor installation.

  • Warning light

    For additional optical hazard detection.

  • Active safety edge

    Ensures personal safety and stops the gate motion.

  • Main switch

    Controls the complete gate system when disconnected from mains (e.g. during maintenance).

  • Rod antenna

    For ensuring a stable radio range.

  • Key switch

    Allows the gate system to be operated only by authorised persons with a key.

  • Connecting cable set for twist 200 E/EL or twist XL

    For connecting a second operator to the control unit housing.

  • Attenuator for inclined gates

    Ideal speed regulation for inclined gates; prevents the gate from rolling down an incline.

  • Battery pack for twist UG, twist AM, RUNner, RUNner+ and SP 900

    Supplies energy to the operator for up to 12 hours for maximum 10 door cycles in the event of a power failure.

  • Memo for twist UG or twist AM

    Is used to expand the memory to 450 transmitter commands. If service is required, the saved transmitters can be easily moved to a new carriage.

    • Product Description
    • Technical Data
    ModelC – S 2000
    MotorImported
    Motor Speed3.6 r/Min
    Output Torque (N.m)2450 N.m
    Voltage (V)440V (Three Phase)
    Frequency (Hz)50 / 60 Hz
    Power Rating (Watt)750 (1 HP)
    Thermal Protector (Built in)125 degree centigrade
    Manual operationChain system
    Lifting Force2000kgf
    Wt of Motor Kg29.00
    • Product Description
    • Technical Data
    MODELC-S1500
    MotorImported
    Motor Speed5.2 r/Min
    Output Torque (N.m)1617 N.m
    Voltage (V)440V (three Phase)
    Frequency (Hz)50 Hz
    Power Rating (Watt)600.(0.8 HP)
    Thermal Protector (Built in)125 degree centigrade
    Manual operationChain system
    Lifting Force1500Kgf
    Wt of Motor Kg22.00
    • Product Description
    • Technical Data
    MODELC-S1000
    MotorImported
    Motor Speed3.75 r/Min
    Output Torque (N.m)809 N.m
    Voltage (V)230V (Single Phase)
    Frequency (Hz)50 Hz
    Power Rating (Watt)400..(0.536 HP)
    Thermal Protector (Built in)125 degree centigrade
    Manual operationChain system
    Lifting Force1000Kgf
    Wt of Motor Kg29.00
    • Product Description
    • Technical Data
    MODELC-S600
    MotorImported
    Motor Speed4.8 r/Min
    Output Torque (N.m)412 N.m
    Voltage (V)230V (Single Phase)
    Frequency (Hz)50 Hz
    Power Rating (Watt)370.(0.5 HP)
    Thermal Protector (Built in)125 degree centigrade
    Manual operationChain system
    Lifting Force600Kgf
    Wt of Motor Kg12.80
    • Product Description
    • Technical Data
    MODELC-S400
    MotorImported
    Motor Speed4.5 r/Min
    Output Torque (N.m)225 N.m
    Voltage (V)230V (Single Phase)
    Frequency (Hz)50 Hz
    Power Rating (Watt)180..(0.25 HP)
    Thermal Protector (Built in)125 degree centigrade
    Motor Insulation (Class)B
    Manual operationChain system
    Lifting Force400Kgf
    Wt of Motor Kg17.5

    Have any question or need any business consultation?